The Creality Space π PLUS Filament Dryer is an active filament dryer with a large-capacity chamber that removes moisture from the material while allowing you to print directly from the dryer. Moisture is the main enemy of quality 3D printing - it causes bubbles, cracking, poor layer adhesion, and reduced mechanical properties of prints.

Key Features

The dryer uses a combination of PTC heating, air circulation, and moisture extraction for efficient drying of filaments made from materials such as PLA, PETG, ABS, ASA, TPU, Nylon, and PC. The extended PLUS version holds up to two spools simultaneously or one large-capacity spool and offers precise temperature and time control. The integrated outlet allows the filament to feed directly into the printer's extruder, so the material stays dry throughout the entire print.

Print and Operating Parameters

Recommended Drying Temperatures by Material

Who Is the Creality Space π PLUS Filament Dryer For

This dryer is intended for all 3D printer users who work with hygroscopic materials, store spools for extended periods, or print technical parts where interlayer adhesion and surface quality are critical. Ideal for advanced makers, small workshops, prototyping labs, and anyone who wants consistent results regardless of ambient humidity.

Usage Tips

• Before the first print from a new spool, run a short drying cycle even if the filament was vacuum-packed.
• For long prints, use the filament feed-through and print directly from the dryer.
• Do not exceed the recommended temperature for a given material - PLA and soft materials can fuse together on the spool.
• After drying, let the spool cool down inside with the lid closed to prevent it from reabsorbing moisture.
• Add silica gel to stored spools to maintain low humidity between prints.
• Regularly check the cleanliness of the PTFE outlet and the lid seal for maximum efficiency.