3DLAC, adhesive spray | 400 ml
3DLAC, adhesive spray | 400 ml

It is used to increase the surface adhesion of 3D printers with a heated substrate. Very effective and simple to use. More
Product code: 3dl_0001 Transport and payment options
7,90 € Tax incl.

It is used to increase the surface adhesion of 3D printers with a heated substrate. Very effective and simple to use. More
Product code: 3dl_0001 Transport and payment options
Shrinkable print materials deform with temperature changes during FDM/FFF printing and, among other things, try to break away from the substrate, which can lead to unwanted deformation of the print or failure of the entire print job. 3DLAC has been developed specifically to improve the adhesion of the print substrate: the odourless spray is easy to apply (e.g. on a cleaned glass surface) and also washes off easily in water after use without leaving stains. Once the print pad has cooled down, many printed materials can be removed with just a touch, without using much force.
With a volume of 400 ml, it lasts for more than 600 pad injections.
Tip: Apply the spray in a thin, uniform layer from about 20 centimetres on a flat, well-cleaned/de-greased surface. Do not try to peel the prints off the still hot substrate, always wait until the substrate has cooled.
Roman Fajt
ProsObrovská výdrž jednoho balení.
Funguje jak má.
ProsObrovská výdrž jednoho balení.
Funguje jak má.
Cons
Cons
Marek Lah
Prosdobrá cena a funkční na sklo
Prosdobrá cena a funkční na sklo
Cons
Cons
Zdeněk Dráždil
ProsSuper pomocník při 3D tisku
ProsSuper pomocník při 3D tisku
Cons
Cons
Pavel Čech
ProsPoužívám pouze na málé součástky u kterých hrozí větší možnost odtržení, ale s tímto sprejem vše dží jak přibité.
ProsPoužívám pouze na málé součástky u kterých hrozí větší možnost odtržení, ale s tímto sprejem vše dží jak přibité.
Cons
Cons
Zdenek Rybnikar
Pros+
Pros+
Cons
Cons
Jan Retych
ProsDrží skvěle všechny materiály. "Nesmrdí" - jen po aplikaci, pak se rychle rozptýlí a není nic cítit. Objem je snad bezedný :) stačí fakt trošičku na k ...more
ProsDrží skvěle všechny materiály. "Nesmrdí" - jen po aplikaci, pak se rychle rozptýlí a není nic cítit. Objem je snad bezedný :) stačí fakt trošičku na každý tisk.
Cons
Cons
Václav Zelený
ProsDobry
ProsDobry
ConsNic
ConsNic
bublich
ProsNejlepší tiskový spray na všechny materiály.
ProsNejlepší tiskový spray na všechny materiály.
Cons
Cons
Vladimír Brůna
Prosšikovná pomůcka
Prosšikovná pomůcka
Cons
Cons
Related Products2

Glass pad for 3D printer | more sizes
from 3,31 € without VAT

Glass - 235 x 235 mm for Ender 3
3,39 € without VAT
Alternative products1

3DLAC Plus (adhesive spray), 100ml
6,03 € without VAT